Sentence examples for rotary experiments from inspiring English sources

Kiil, C.E. Weinell, M.S. Pedersen, K. Dam-Johansen, Analysis of self-polishing antifouling paints using rotary experiments and mathematical modelling, Ind . Eng

In fact, the samples recovered from the Japan trench show a dynamic weakening during high-velocity rotary experiments, which can explain shallow slip and heat anomalies in the slip zone during the Tohoku-oki earthquake (Ujiie et al. 2013).

The values of relative blood viscosity for four chosen shear rates, measured in the rotary experiment, are listed in Table 1.

For verification purposes, the cold rotary forging experiments of 20CrMnTi alloy spur bevel gears are subsequently conducted.

Rotary shear experiments were performed using the hydrothermal ring shear machine (Additional file 1; for further details, see Niemeijer et al. 2008 and Den Hartog et al. 2012a).

Yellow triangles are the data obtained through rotary shear experiments on the plate boundary fault collected at the Japan Trench (Expedition 343; Site C0019), reported in Ujiie et al. (2013).

Rotary shear experiments were performed at an effective normal stress of 170 MPa, a pore fluid pressure of 100 MPa or under vacuum (i.e. dry), at temperatures of 200°C to 500°C and at sliding velocities stepped between 1, 10 and 100 μm/s.

Other symbols are experimental results obtained by rotary shear experiments on sediments that occur around faults in the Nankai Trough (Expedition 316; Sites C0004D and C0007D), from Ujiie and Tsutsumi (2010), Tsutsumi et al. (2011), and Hirose et al. (2008), shown for comparison.

Finally, the dynamic angle of repose of the EG particles is obtained by a rotary cylinder experiment to further verify the calibrated parameters.

The processing conditions were optimised by quadratic general rotary unitised design experiments.

To do so, rotary bending fatigue experiments were performed on the base alloy samples before and after oxidation at 600 and 750 °C for 2 h.