Sentence examples for rolling planar from inspiring English sources
This study was conducted in two topographically distinct cold regions research basins in the north-west of Canada characterised as tundra environments, one an alpine mountain tundra at 60°N and the other a rolling planar tundra at approximately 70°N.
Planar (rolling) shear properties in cross laminated timber (CLT) is an important factor that should be considered for CLT structural components with short span or openings.
This paper deals with planar rocking and rolling of an elastic pseudo-rigid membrane on a fixed straight line.
The dynamic model describes the rolling locomotion which is limited to planar one by an assumption that the hexapod robot does not fall down while rolling and influences due to collision and contact with the ground, and it is applied for computing the mechanical energy of the hexapod robot and a plant for a numerical simulation.
The failure mode of HCLT with LVL as cross layer in planar shear test was shear failure along the glue line direction, however, the typical failure modes of HCLT with SPF as cross layer in planar shear test included rolling shear failure along the growth ring direction, shear failure along the wood ray direction and shear failure along glue line direction.
We first present a novel planar leg model which incorporates rolling kinematics and a new compliance model, motivated by the use of similar leg designs on existing platforms.
In these layers, extended planar dislocation boundaries are frequently found to be inclined closely to the rolling direction.
Changing arrangements of 111 diffraction spots relative to the samples' rolling and crack propagation directions are found to correspond to the transitions between a relatively planar section of the crack and an adjacent asperity.
Open and closed loop control design for the planar motion of a unicycle model consisting of a double pendulum mounted on a rolling wheel is considered.
In this case, grains are subdivided by extended planar dislocation boundaries preferentially aligned at an angle of 40 ± 15° to the rolling direction.
