Sentence examples for roll surface from inspiring English sources

Initial examination of the roll coating generated on the work roll surface revealed it was patchy, discontinuous, streaked in the rolling direction and composed mainly of aluminum, magnesium, oxygen and carbon.

Much less roll surface is now required than was needed as recently as the 1940s.

Damage to the work roll surface and work roll debris observed within the roll coating highlighted that the work roll surface was involved in the roll coating formation.

Predictions of minimum roll surface separation compare well with published data.

The tendency for sticking occurrence decreased with increasing strain rate and decreasing the hammer or work roll surface roughness.

The tests provide a distribution of cooling intensity (heat transfer coefficient and heat flux) at the roll surface.

Roll surfaces typically are smooth, serrated, or pocketed.

The results indicated that oxide scale could avoid the direct contact between roll surfaces and rolled materials to help reducing the sticking occurrence.

The CI and CSP at the casting-roll surface of a melt-cast and biaxially oriented nylon 6 (N6) film is the same as in the bulk, but the air-exposed surface has lower CI and CSP than the bulk.

The state variables were then incorporated into a new dynamic recrystallization (DRX) model that considers both continuous dynamic recrystallization and geometric dynamic recrystallization to predict grain structure evolution near the rolled surface.

Aluminum and magnesium transfers were observed on all work rolls' surfaces from the 1st hot rolling pass.