Sentence examples for rod samples from inspiring English sources

Fig. 7 Absorbance (in reflectance mode) of ZnO rod samples.

The microstructures of the rod samples were characterized by high-resolution transmission electron microscopy (HRTEM Philipss Tecnai F20 G2).

Using vinylester and unsaturated polyester resins, the hybrid FRP rod samples were pultruded and tested for tension.

A series of rod samples with diameter of 2 mm Zr65Cu17.5Al7.5Ni10 xFex (x = 0, 2, 4, 6, 8, 10) were prepared by injection copper mold casting method.

A series of Zr65Cu17.5Al7.5Ni10 − xCox (x = 0, 2, 4, 6, 7, 8, 10) rod samples with 2 mm in diameter were prepared by injection copper mold casting method.

The morphology of the fracture surfaces of extruded rod samples showed a sheet-like structure which consisted of ribbons and fibres oriented along the flow direction.

The as-cast rod sample did not fracture even at a compressive engineering strain of above 50%.

The number of attached and grown cells on the rod sample is higher than the sheet sample also the scanning electron microscopy (SEM) analysis of ADSCs grown on the samples demonstrates higher cell density and spreading pattern on the surface of rod sample.

The deconvolution of Cr 2p3/2 (2p1/2) and O 1s suggests that the surface of the CrO2 rod sample contains a mixing of Cr oxides rather than the reported formation of single phase of Cr2O3 in the previous works [4, 5, 8].

In differentiated ADSCs on the rod sample the expression of all genes except ANF are detectable, while on the sheet sample only the MEF2C and β-MHC are expressed.

Post-mortem X-ray micro-computed tomography (micro-CT) imaging has shown that fibre kink bands predominantly all lie within the same plane in a cylindrical rod sample uniaxially compressed without lateral constraint.