Sentence examples for rf shield from inspiring English sources

A high-critical temperature superconductor which employs perfect diamagnetism, is an ideal material for use as a radio frequency (RF) shield.

An RF shield was constructed to reduce the noise coupled into the receiver, and to add isolation from the clock signals.  .

An RF shield was constructed to reduce the noise coupled into the receiver, and to add isolation from the clock signals.

This setting ensures that when individuals wear the devices on their chest, exchange of radio packets between RFID devices is only possible when they are facing each other, as the human body acts as a RF shield at the carrier frequency used for communication.

Electrical grounding of the transducer to the magnet room's RF shielding was achieved by wrapping it, and its 8 m cable, in a layer of aluminium foil, and partially closing the magnet room door to maintain continuity of the RF shield.

Metal can act as an RF shield so if you are experiencing a weak connection check for metal surfaces that might be obstructing the path from the gateway to the adapter.

The temperature was measured using a Chromel Alumel type K thermometer mounted on a removable substrate table and RF shielded via a braided stainless steel sheath.

HFI has three degrees-of-freedom (DOF), uses electromagnetic motors to enable high-fidelity haptic rendering (>350Hz), integrates radio frequency (RF) shields to prevent electromagnetic interference with fMRI (temporal SNR >100), and is kinematically designed to minimize currents induced by the MRI scanner's magnetic field during motor displacement (<2cm).

This coil is characterized by major advantages: (i) completely distributed coil circuit, (ii) high-quality factor (Q), (iii) simple coil structure, and (iv) better sensitivity and less signal-intensity variation in the MR image of the human head compared with an RF shielded birdcage coil of similar coil size.

The measurement system consists of the N210/DBSRX2 receiver combination inside of an RF shielded enclosure.

A 1.5-μm thick aluminum ground layer is deposited on the silicon nitride film by sputtering and dry etched to provide a ground plane for RF shielding and to form wire bonding pads of DC electrodes (Figure 6(b)).