Y1, retention time at approximately 12.3 min; Y2, retention time at approximately 13.3 min; Y3, retention time at approximately 17.2 min; Y4, retention time at approximately 20.1 min.
The profile of intracellular pigments determined by HPLC-PDAD at 388 nm. 1, Monascin, retention time at approximately 26.7 min; 2, Ankaflavin, retention time at approximately 30.7 min; 3, Rubropunctation, retention time at approximately 26.9 min; 4, Monascorubrin, retention time at approximately 31.6 min.
For the VG comparison, Figure 5a shows a temporally persistent EVP in β at electrode FC2 during the retention interval (which started at approximately 3.9 sec and ended at approximately 4.4 sec).
Pure mCP component was collected at its characteristic retention time (approximately 20 min).
The initial discharge capacity is as high as 168 mAh/g at 0.1 C rate, and the capacity retention is approximately 100% after 100 cycles at 1 C rate, almost no capacity fading.
Porphyra and a further unknown compound, absorbing at approximately 328 nm and with a retention time of 3.8 min, were found in the respective Chlorella.
Moreover, a shoulder at the main elution peak, as well as a small peak at a retention time of approximately 10 min, indicate some aggregation.
High resolution XPS analysis of the deposit registered a C 1s spectra typical of poly acrylic acid) with a prominent peak centred at approximately 289.3 eV indicating a relatively high level retention of the original monomer functionality.
For complex 2, the major peak with a retention time of approximately 1.6 min was accompanied by a minor peak at approximately 1.7 min, which accounted for about 16%% of the total peak area.
The wet synthesis of these Fe3O4/C18 nanoparticles leads to the retention of approximately 2.84% humidity which is lost at heating (below 180°C).
