Sentence examples for restore voltage from inspiring English sources

The objective of reactive power injection is the same as the load shedding, which is to restore voltage at each bus to its low limit.

Whereas, secondary control has two control objectives: 1) to restore voltage and 2) to share the load in a suitable proportion.

For example, activation of phosphorylation pathways by protein kinase A was able to restore voltage-dependent potentiation of L-type Ca2+ channels in mdx fibres [67].

In this case, the series-connected AC/DC VSC has to inject a series voltage to restore the voltage prior to the fault.

In this method, reactive power is injected at the nodes with the voltage violations to restore the voltage.

The agents communicate to restore the voltage and frequency to their nominal references.

However, the DESS 3 is so far from node 14 that it cannot restore the voltage even at maximum power.

These error signals are the voltage correction term (V_{err_1}) and (V_{err_2}) that restore the voltages at MG1 and MG2 buses and are added to the droop control unit of each MG.

Focused on long-term voltage stability, this paper presents a real-time voltage control scheme using measurement-based aggregate load model to restore system voltages following a contingency.

To restore the load voltage, dynamic voltage restorer (DVR), which installed between the supply and a sensitive load, should inject voltage and active power from DVR to the distribution system during voltage sag.

While the power sharing has finished, S is set as 1, the voltage compensation variables are added in droop control to restore the inverter voltage.