Sentence examples for respective density from inspiring English sources

While the oil and gas permittivity is known from information about their respective density, water permittivity depends on the salt content.

Acinetobacter spp and Pseudomonas Aeroginosa were the predominant isolated microorganisms with a respective density of 13.2 and 11.2 isolates for 100 patients.

This is done by multiplying the CV values of the density curve for the lower activity concentration by the ratio of the mode values of the respective density curves (see Equation 1).

and are the respective density restriction terms of the immature prey species and predator species. is the predation rate of the predator to the immature prey population, and is the conversion rate of the predator.

Mass of each scraped silica sample was measured by weighting with the 4 decimal place analytical balance and the respective density was calculated by division of mass by the volume of silica coating (2 cm × 2 cm × layer thickness in cm).

is the net mortality rate of predator population, and the survival of predator species is dependent on the survival state of prey species, and are the respective density restriction terms of prey and predator species. is the predation rate of the predator, and is the conversion rate of the predator.

The respective densities of red and green points show a good correspondence with the ground-truth image area classification.

Sand was used as the bed material with mean diameter of 143 μm, 256 μm and 363 μm with respective densities of 2631, 2564 and 2740 kg/m3.

Also illustrated are the mean values of the respective densities and the true state It can be seen that the EnKF solutions sometimes resemble the PMF very well but not always.

Ishihara and Koda (2007) gravimetrically estimated the crustal thickness of the Philippine Sea plate using a simple four-layer model, which comprised seawater, sediments, crust, and lithospheric mantle, with respective densities of 1,030, 2,300, 2,800, and 3,300 kg/m3.

The basis function can be adjusted by means of shift, shear, and scaling operators, resulting in a five-dimensional parameter space for the energy density which comprises as projections the respective densities obtained from a short-time Fourier transform (time and frequency shift) and a wavelet transform (time shift and scaling).