Sentence examples for resistive pressure from inspiring English sources

By the sudden interruption of (inspiratory) airflow, the respiratory pressure instantaneously drops by the amount of the resistive pressure fraction (airflow rate immediately preceding flow interruption multiplied by the Newtonian resistance of the respiratory system).

Pan, L. et al. An ultra-sensitive resistive pressure sensor based on hollow-sphere microstructure induced elasticity in conducting polymer film.

Expectedly, target resistive pressure increases with confinement impedance but decreases with projectile diameter.

The effects of various parameters such as nose shape, impact velocity and unconfined compressive strength are considered in the formulation by the mean resistive pressure which consists of two parts, namely, cohesive static resistive pressure due to the elastic plastic deformations and the dynamic resistive pressure arising from velocity effects.

The influence of the atmospheric pressure on the gas sensor output data is compensated with an implemented MEMS piezo resistive pressure sensor.

Equipment resistive pressure (Req/V') was subtracted from pulmonary resistive pressure so that the results represent intrinsic values.

Because the initial part of the V-P curve reflects the pressure needed to overcome resistive pressures, including the resistance associated with an ETT, it contributes to the widening of the dynamic V-P loop.

And since it's not exactly a traditional resistive (pressure-only) resistive input method, it could also use capacitive clues to make it more refined as well as being much more sensitive to changes in pressure than capacitive systems.

The resistive pressures induced by the two constant flows, which were defined as the initial increase in the airway pressure until the inspiratory flow becomes constant, were 1.0 ± 1.0 and 1.8 ± 2.1 cmH2O,respectively.

To simulate airway obstruction, fixed orifice resistors producing resistive pressures of 20 cmH2O/l per s (Rp20) and 50 cmH2O/l per s (Rp50) were placed between the distal end of the coaxial circuit and the filter.

The measurement from each individual fibre optic sensor is generally consistent with conventional piezo-resistive pressure transducers over a wide frequency range.