Sentence examples for resistance flow from inspiring English sources

The purpose of this investigation is to evaluate technical feasibility of improving oil recovery and the extent of resistance flow through porous media of CGA fluid.

The US geological survey (USGS) energy resource program has classified crude oil depending on their API (i.e. American Petroleum Institute) gravity [i.e. (141.5/sp.g at 60 °F)––131.5] and viscosity (i.e. the resistance flow) of the oil as follows (Meyer and Attanasi 2003): Light oil (or conventional oil) has API gravity greater than 22° API and a viscosity <100 cP (see Fig. 1).

Rheological tests indicate that most of asphalt blends exhibit improved performance at higher temperature with grafted polyethylene such as enhancing rutting resistance, flow activation energy and superior time temperature-dependent response as compared time temperature-dependentene blends.

The results reveal that the peak power density can be as high as 435 mW cm−2 according to the area of the air cathode sheet, and the influence factors on cell performance and uniformity are cell locations, filled state of zinc pellets, contact resistance, flow rates of electrolyte and air.

Interestingly, one study [ 3] documented that the proximal supra-testicular artery (which was not examined in the present study) had a biphasic high resistance flow profile similar to that observed in stallions [ 20].

Treatment, specifically, induced reduction of microvessels inside the tumour could be identified as a decrease of BV values while a decrease of BF could indicate a reduction of low resistance flow arteriovenous shunts in the microvasculature.

These principles include compliance, elastance, resistance, impedance, flow, and work of breathing.

Because of their excellent performance properties (evaporation rate, blush resistance, flow-out and leveling properties, solubility for coating resins, solvent activity, mild odor, good coupling ability, good solvent release) a complete line of ethylene oxide-based solvents of various molecular weights has been developed.

In humans, when the internal and external carotid arteries are within normal standards, they can be singled out based on their spectral traces; both the internal and common carotid arteries present low-resistance flow, whereas the external carotid artery presents high-resistance flow [ 12].

Both new designs used a tree like structure to expand flow more evenly; one of these designs also included perfusion barriers intended to improve uniformity by creating an array of equal, high-resistance flow paths.

This is achieved by converting arteries from high resistance low flow to high flow low resistance arteries [ 14].