"residual frequency" is a valid term in written English.
This term is often used in fields related to mathematics, science, engineering, and computer science. For example, you could use the phrase "residual frequency" when explaining some behavior of a physical system by stating "The residual frequency of the system was found to be 0.3 Hz."
Figure 3 BER degradation due to the residual frequency offset in MIMO-OFDM systems.
Typically, ±250 Hz residual frequency offset range is considered acceptable at the acquisition stage.
Residual frequency offset which was less than 100 Hz was included in the estimated channel.
Therefore, the residual frequency offset and channel estimation errors impact the BER performance.
We extend previous studies on collision-induced residual frequency shifts in wavelength division multiplexed strongly dispersion managed soliton systems.
In the equivalent model (b), the effect of inaccurate CFO estimation is represented by the residual frequency modulation.
When the log-linear analysis of frequency was significant, the residual frequencies, i.e. the observed minus expected frequencies, were estimated for each cell of the two-factor comparison and then standardized and tested for significance.
The first pattern is characterized by the dominant presence of the ancestral haplotype (all of whose alleles are ancestral), whereas the second includes loci where the ancestral haplotype is absent or is present only at residual frequencies.
Apical area strain was defined as cell area relative to a cell area trend computed using a moving window of 6 min. High-frequency noise, residual low-frequency and neighbour effects in both area and rescaled myosin signals were removed via a bandpass filter in the range 1 mHz≤ ν≤12.5 mHz.
When we use the undecimated wavelet transform, a LR image can be decomposed into low-frequency, horizontal, vertical directional and the residual high frequency components [13].
As in [10], we consider a quasi-synchronous system in which no interblock interference is present at the BS receiver, and we neglect any residual carrier frequency offset.b Moreover, we assume that the channel frequency response is nearly flat over each tile and independent across tiles.
