Sentence examples for requirements of sensitivity from inspiring English sources
The experiment shows that the sensitivity of three coils in the sample sensor achieves 22.38 nH/mm2 both for left and right coils, 22.84 nH/mm2 for top coil, which can meet the requirements of sensitivity for testing the contraction situation of uterine musculature.
To enable the sensor to meet the requirements of sensitivity and selectivity, dendritic platinum nanoparticles (DPNs) with a high surface area were prepared and directly coated on gold nanoparticles deposited on a screen-printed carbon electrode, followed by the deposition of a polyethyleneimine-phosphatidylcholine (PEI-PC) layer.
The assay was rigorously tested and requirements of sensitivity, specificity, stability and good recovery were fulfilled.
It is found that the requirements of high sensitivity and large vibration displacement are contradictory.
Nanomaterials are suitable candidates to fulfill requirements of high sensitivity and selectivity in solid liquid phase extraction and removal of organosulfur compounds from liquid hydrocarbon fuels [10].
This extraordinary property could be engineered by adopting synthetic biology or biomimetic chemistry to obtain tailor-made biosensors having the desired requirements of robustness, sensitivity and detection range.
The scheme must be capable to meet the basic protection requirements of selectivity, sensitivity and reliability not only in grid-connected mode but also in islanded mode of operation.
In order to meet the requirements of high sensitivity, low noise figure, and low power of the system, the total power consumption of the subsampling receiver should be less than 4 mW and the total voltage gain of the system cannot be less than 60 dB when the subsampling receiver achieves −85 dBm sensitivity at 10−3 BER.
Today, FACS and MACS remain the most widely utilized methods, but limited sample amounts coupled with requirements of high sensitivity have spawned the development of a broad range of microfluidic cell separation methods.
Based on regulatory requirements, a number of sensitivity analyses were carried out.
From the requirement of high sensitivity, LA should be performed using high energies and repetition rates, while keeping the number of shorts per point at a minimum.
