Sentence examples for requirements of extraction from inspiring English sources

Two levels of energy demands (i.e. high and low energy scenarios), reflecting the range of variability in the energy requirements of extraction and upgrading operations (e.g. steam to oil ratio), are considered.

The water requirements of extraction processes are an additional economic consideration in regions where water is a scarce resource.

High priority should be given to improvement in the accuracy of direct assays and the sample volume and labour requirements of extraction assays.

The minimum energy requirements of extraction-based separation systems, feeding a water concentration in the substrate equivalent to extractant selectivity, and ideal assumptions were between 2.6 and 3.5 MJ-fuel/kg-ABE, respectively.

Energy requirement of extraction mixture was between 1.7 and 23% lower than that for HTE (Table 3).

The current result shows that, the design considers the complexity of the compact cyclotron extraction area and fits the requirements of the extraction and transport for high intensity proton beam, especially at mA intensity levels.

Construct validity and factor structure were determined through the use of questionnaire principal component analysis (PCA) with the a-priori requirements for extraction being the satisfaction of all three points: screeplot inflection point, Eigenvalue > 1.0 and accounting for >10% of variance.

Requirement of smoke extraction system and smoke curtain is also exempted from article 188 of Standard for Installation of Fire Safety Equipment Based on Use and Occupancy.

The requirement of timely extraction of high quality nucleic acids for molecular analysis is faced with specific challenges when used to study the influence of microorganisms on oil production.

The dual-QDs-labeled LFS has comparative advantages in that firstly, whole blood can be detected by it without requirement of serum extraction; secondly, simultaneous quantification of CRP and PCT can be conducted within 20 min by using only 100 μL of the blood; and thirdly, its paired equipment for fluorescence detection is simple to operate and also at a low cost.

Sensitivity of sterol detection in this test is approximately 8 ng in intact membranes, with no requirement of lipid extraction.