Sentence examples for requirements for delay from inspiring English sources

The interest of their introduction as a function of the chosen architecture, i.e. hybrid (i.e. air cavities at metal levels with a low-K material at via level) or full homogenous air gaps with an effective relative constant close to 1, is discussed in terms of signal propagation requirements for delay, crosstalk and delay increased by crosstalk.

If the requirement for delay is high, the weight of delay will be large; for example, when only the delay is considered, the shortest routing method is appropriate.

Most of the current ongoing proposals include a signaling overload that increases the difficulty of satisfying the performance requirements for handover delay specified in IMT-Advanced.

It is necessary to highlight the point that the QoS requirements (for example delay) for the RT CTRqs are included in the demanded des_TU, thus in the calculated RT satisfaction factor.  .

Finally, some PRs blamed the Global Fund's changing requirements for the delays.

Nevertheless, there are generic differences that remain regarding requirements for specific delays and the magnitudes of global robustness for the oscillatory phenotype, and the results of careful comparison suggest a best design among the alternatives.

The simulation results of packet loss ratio, average waiting delay and rate show that the proposed algorithm can meet the requirement for time delay and rate fairness, raise the spectrum efficiency and improve the quality of service.

The requirement for longer delay in the negative versus positive loop to facilitate oscillations would naturally be favored by the additional processes in the negative feedback loop of their construct.

Direct evidence for the requirement of delay in feedback repression in the mammalian circadian clock has been elusive.

In addition, the requirements for the time delay between the auxiliary contact and main pole are also not clear, especially when the circuit-breaker position is wired from an intermediate relay or other middle stages.

Since the real-time flows have stringent QoS requirements (for e.g., the delay for an acceptable VoIP flow should be less than 200 ms according to the ETSI recommendation [7 9] and the loss rate should be no more than 1%), it is easy to conclude that the increased delay (0.05 s to 0.45 s) and reduced throughput of flow 2 will have an adverse impact on the perceived quality of the flow.