Sentence examples for required transverse from inspiring English sources

Towards this goal, herein a multi-step biaxial bias extension (MBBE) characterization test has been proposed to assess the magnitude of the required transverse de-wrinkling forces that can smooth out wrinkles of different sizes, formed at different shear angles of a plain weave fabric.

However, it is almost impossible to place diagonal reinforcement groups at a right angle to all the required transverse bars required for the diagonal confinement and full-section confinement found in ACI 318-05 (2005) and ACI 318-08 (2008), respectively (Hajyalikhan 2015).

Following adjustment of all predictor variables, those with class II malocclusions were associated with short duration of treatment time (estimate is −5.83, p = 0.02) when compared to those with class III malocclusions, and those that required transverse expansion were associated with longer duration of treatment (estimate is 10.21, p = 0.001).

Following adjustment of all predictor variables, those that required transverse expansion were associated with significantly more number of visits (estimate is 8.64, p = 0.009) and those that were treated in USA were also associated with significantly more number of visits (estimate is 6.36, p = 0.03).

The reported results indicate that a stable pattern of secondary currents over the entire channel width can only be sustained over a fixed horizontal bed if the bed's roughness is sufficient to provide the required transverse oscillations in the turbulent shear stresses.

Last but not least, if required, the transverse position of the particles could also be controlled by modifying the center coordinate of the split lens structure.

This paper presents a more accurate calculation of the minimum stiffness required for transverse stiffeners of compression panels.

Thus, all the tensile reinforcement in the slab can be removed, except that required for transverse negative moments induced by loads on the deck slab overhangs.

The introduction of stressed crack faces in the core enables a subdivision of the applied shear force into a concrete and a steel contribution, allowing the determination of the required minimum transverse reinforcement ratio that enforces a ductile flexural failure.

At distances greater than that required for transverse homogenization, an effective longitudinal dispersion coefficient can be defined that describes this enhanced dispersion for a wide range of fluid velocities.

Because the phase of each diffracted beam must be well defined, a highly parallel x-ray beam is required: the transverse coherence length should be at least twice the particle diameter [10].