The phrase "required torque" is correct and usable in written English.
It can be used to refer to a specific amount of torque which is needed to perform a certain task, either mechanically or electronically. For example: "We need to use a wrench with sufficient torque to ensure that the bolts are tightened properly; the required torque is 70 Newton-meters."
The design of the coupling should provide for transmission of the required torque at the required speed with a minimum of extraneous forces and perturbations exerted on either the driver or driven shaft.
A lower stress on the shafts and a reduction of the required torque were also observed.
The shaft design and particularly shaft end design to transmit the maximum required torque are examined.
By experimentation, it was found that the stepper motors would not have the required torque to move the EAS knobs when the stepping frequency was above 500 Hz.
For the mixing of the lighter particles, the contra configuration with inward opposing flow gave optimal performance of highest mixing efficiency at lowest required torque.
During testing the required torque and thrust are monitored and logged, making it possible to measure various soil soil conditioning matrixes requirement for operational parameters.
The link lengths are obtained using a numerical optimization algorithm and by considering constraints such as the maximum required torques and forces at the end-effector.
This velocity is passed onwards to a low-level impedance controller which sends out the required torques.
In spite of the display of torque output on an oscilloscope, the actual torques corresponding to 20, 40, 60, and 80% TMVC instructions were not exactly equal to the required torques.
An alternative method for the mechanical power calculation is also discussed which does not require torque measurement device and thus is highly useful for common laboratory measurements.
The reasons for spending the extra cash would be: you need to work far away from a mains supply you would be standing on a ladder or somewhere else where having a cable could be dangerous you are using a lot of self-tapping screws, which require torque at low revs.
