Sentence examples for required coefficient of from inspiring English sources
A slipping incident occurs when the required coefficient of friction (RCOF) exceeds the coefficient of friction (COF) at the claw floor interface.
The study assessed the required coefficient of friction of 10 male subjects as they exited cab-over-engine and conventional tractors, a step-van, the back of a box trailer, and the back of a cube-van.
The required coefficient of friction data of one participant, who repeatedly walked on this walkway under four different walking conditions, is presented as an example of the readiness of the methodology examined in this paper.
In brief, during the tilting operation and during the pushing operation, there is a big difference in the required coefficient of friction between the handcarts and the floor surface.
This need for care is reinforced by the assay's total imprecision being much higher at the low end of the measurement interval compared with the required coefficient of variation 10% or less at the 99th centile.
I wrote an assembler for the cpu and a preprocessor which takes filter specification input and generates a table of required coefficients in a format suitable for pasting into the assembler code as the data section.
Instead of a repetitive and time-consuming process, the proposed spatial captive motion could provide all necessary information for determination of all required coefficients in only one simulation.
The spacing between points is s, so that the number of required coefficients is approximately (N_g simeq left( frac{N_2}{s} right) ^2).
Only coefficients with order ǀmǀ ≤ 1 are used, since we are fitting a latitudinal profile sampled over a partial orbit, with a limited variation of longitude and altitude, and will use quasi-dipole coordinates (see below) to reduce the number of required coefficients.
All independent latent variables meet the required minimal coefficient of determination (R2) value of 0.3 and are thus sufficiently explained [49] (see Table 10).
The toroidal vessel with larger relative bend radius requires lower coefficient of friction between the fiber bundle and the supporting surface.
