Sentence examples for replication ratio from inspiring English sources

It was shown that the replication ratio of optical micro-structures can be increased significantly up to 20 30% by using a PVD coated in comparison to an uncoated mold.

For example, we used two PCR primer sets to test two points in an island that overlaps a Woodfine marker with a replication ratio of 1.51.

Another island, also tested for replication timing, was one of the few that were very late replicating, with a replication time of 5.6 and 5.5 hrs and overlapping markers with Woodfine replication ratio of 1.36 and 1.25.

Therefore, the Calvin cycle, and the formation of PGA, is autocatalytic but the replication ratio of PGA is 4/3 instead of two as in the case of the formose cycle regarding glycolaldehyde.

This is completely independent of the fact whether Bs are needed in stoichiometric amounts or only one B is needed for all steps to be catalyzed in all the parallel cycles, since the total amount of B will be increased; thus, the replication ratio of B will be larger than one.

We also investigated regions of 22q where a total of 28 islands overlapped markers from the high-resolution array where the Woodfine et al. [ 19] data suggested an early replication time (replication ratio ≥ 1.75) and where chromatin data was also available [ 22].

The mE1a expression allowed efficient adenovirus replication with high and stable replication ratios in cancer cells (about 125- to 8500-fold higher at 48 h and 180- to 10,900-fold higher at 96 h post-infection).

Additionally, PCR marker chr6.1395C, which is located in a region with a replication timing ratio of 1.58, replicates at 5.4 hrs, as do primer sets A and B from that same island that have Woodfine replication ratios of 1.36 and 1.25.

For example, clone island chr22.1110 overlaps markers with Woodfine replication ratios of 1.55 and 1.55, but testing of two PCR markers in this island indicated that in fibroblasts it replicated in the first hour, not in the middle of S phase.

In Fig. 2, X-axis shows the modularity value and Y-axis shows the replication factor ratio of the partitions obtained by our technique to those obtained by random partitioning and HDRF.

Y-axis shows the replication factor ratio of the partitions obtained by our technique to those obtained by random partitioning and HDRF. Figure 3 shows the results of the experiments for replication factor by varying the number of computers, 8, 16, 32, 48, 64.