"remove irregularities" is a correct and usable phrase in written English.
You can use it when you want to indicate that something should be made even or regular, usually in terms of structure or form. For example: "We need to remove any irregularities present in the data before proceeding with the analysis."
The result shows that the proposed metric could be used to provide an overall quality assessment of object oriented software system in early stage of development life cycle, which may be helpful to the developer to fix problems, remove irregularities and non-conformance to standards and eliminate unwanted complexities in the early development cycle.
Greater than 1000 spots were found on each gel and after filtering to remove irregularities, 818 spots were used in the analysis across all gels (Figure 2, Supplemental Table S2).
When the correct disparity is between two consecutive pixels the third matching cost value (C3) must correspond to an incorrect disparity which if the pixel at (x y) is reliable should yield relatively high matching cost resulting in high value of the confidence measure C t. Another common post-processing approach is the use of the median filter that smoothes and removes irregularities [10].
The bark is removed in the forest or factory, and poles and posts are further processed by shaving to remove surface irregularities, by framing (boring holes and making necessary cuts), and by incising (punching slitlike depressions to facilitate the entrance of preservative chemicals).
Thus, we accept that the use of 0.2-bins will be sufficient to remove the irregularities.
When beginning a restoration, he and Ms. Valint make any necessary carpentry repairs, treat the ribs and other wood with a near-boiling mixture of linseed oil and turpentine to restore flexibility, replace the canvas on the canoes and spend hour after hour with sandpaper in hand, removing any irregularities, and often, many layers of paint.
Finally, another set of morphological closing operations removes spurious irregularities to this improved silhouette and leads to the final contour of the human body, which is used in the following experimental sections.
The use of siliconized points (S2) was insufficient for removing the irregularities created with diamond points, resulting in higher values of Ra.
The shape was eroded three times, then dilated three times (erosion and dilation see Burger et al. [5]) to remove small border irregularities and afterwards larger irregularities in the contour were filled by computing local contour tangents and correcting parts of the contour which deviate too much from local contour curvature.
As the main role of polishing is to remove the microscopic irregularities of the surface, the smaller removal amounts the better the surface uniformity based on the condition that the accuracy of polishing is ensured.
The glass was slowly stirred in the molten state to remove striations and irregularities, and then the whole mass was cooled and broken up into suitable pieces for lens making.
