Sentence examples for removal velocity from inspiring English sources
The fluoride removal capacity (qe) increased rapidly within 5 min and reached equilibrium within 10 min, which indicated a rapid removal velocity of fluoride by PANI under this condition.
The evolution of water-water interface at the initial stage of dam break flow and the analysis of gate thickness, gate removal velocity and ambient water depth effects are further examined.
Since the flowing characteristics of interacted soil, such as removal volume, coring height, removal velocity and accumulation angle, directly reveal the drilling conditions, they are enhancing resources to comprehend the sampling phenomenon and can be used to help control the drill tool.
The oxide removal velocity is unchangeable in this case, which prevents pore diameter from being enlarged.
The rectangular shaped Li jet (cross-section 25 mm × 100 mm) necessitates for heat removal flow velocities of 15 20 m/s along a concave shaped back wall (curvature radius 250 mm) towards the outlet pipe, where the Li jet is subjected to vacuum before it finally enters the collecting quench tank.
It can be concluded that among the systems evaluated, the Guelph-L at an inflow-rate of 12 L min−1 was most efficient for both solids removal and water velocity profile and thus seemed more suitable for shrimp digestibility studies in high performance conditions.
COD removal efficiency, sludge settling velocity (SSV), electrode consumption and energy consumption under the optimum conditions were measured, which were 40%, 0.004 cm/min, 1.3 kg/m3 and 7.64 kWh/m3, respectively.
Through these experiments, it was shown that the new fiber filter design was very efficient for particle removal at a filtration velocity of 60 m/h (1500 m3/d) and 1 mg/L coagulant dosage, and these were considered as the optimal operating conditions.
Using an endovascular OCT system with custom-built data acquisition system and phase shift artifact removal algorithm, minimal detectable velocity was characterized in a slow flow phantom.
Type of grit removal is horizontal with surface velocity and tank floor velocity of 0.45 and 0.3 m/s, respectively.
Experimental results of the phenol removal at different inlet velocities were compared to those obtained using the simulation data.
