This discrepency results from the different sensitivity of each methods with regards to the release of orientation.
That is, a cricket sometimes ran toward the arena wall after release without orientation and then walked along the wall.
The diaphragms were released using orientation-dependent wet etching (ODE) with 5 10 μm residual silicon layers.
The latest step(s) on the Olympic road to Sochi, Russia, came on Monday when various national hockey federations released their orientation camp rosters.
In particular, release from cross-orientation suppression serves to enhance the visibility of orientation flows that are the keys to decoding 3-D shapes as signaled by texture ([3], [2], [5]), shading ([39]), and specular reflection ([40]).
The protein molecules can be bound and released in both orientations but with different rate constants and also change their orientation in the bound state (Fig. 4).
A release and the orientation of the PCL were included as independent variables, and their effect on the flexion gap dynamics, on the gap-anterior translation ratio, and on the change in PCL elevation (all three dependent variables) was investigated.
After the song's release, across all sexual orientations, women's sexuality took a serious hit, and lesbian sexuality was similarly exploited: Girl-on-girl experimentation was seen as women lacking self-control rather than as women asserting their sexual agency.
Similar to other injection techniques, there is always a low risk for potential wall perforations and ventricular arrhythmia caused by either alterations in the gap junction orientation or release of inflammatory stimuli [ 121].
Wet anisotropic etching has several advantages over dry etching including low cost, simple experimental setup, easy handling, batch processing, orientation dependent etch rate, unmatched capability to release mechanical structures, etc. Orientation dependent etch rate is employed to develop microstructures with vertical as well as slanted sidewalls.
However, the fraction of the particle surface where volatiles are released and its orientation in the bed should be better determined in order to increase the accuracy of the estimates of turbulent mixing.
