Sentence examples for relative interface from inspiring English sources

Furthermore, a reduction of the non-linear system to relative interface displacements is introduced to decrease the computation time.

Good agreement was found among the calculated relative interface energies, reports in the literature, and the present experimental data.

The concept of the minimum relative interface displacement sm is introduced and used as the fundamental variable to express all other parameters, such as external tensile load.

The intervariant plane distribution in martensite was determined more by the constraints of the phase transformation than by the relative interface energies.

The principal aims were specifically to evaluate the effect of (i) relative interface area (ratio of specimen surface to cell layer surface) and (ii) volume of cell culture medium on cytotoxicity as a potential modification of ISO 10993-5.

The concept of the minimum relative interface rotation ϕm is introduced and used as the fundamental variable to express all other parameters, such as external torsion load, distribution of interfacial shear stress, length of elastic zone and softening zone, etc.

With several large clinical research studies enrolling thousands of patients and relatives, interfacing with such initiatives would further the nPOD mission and ultimately advance diabetes research.

While the interfaces with λ below this zone are shown to be a "relative rough interface", then type III and IV of the interfacial cracks are preferred in them.

At the low-energy side of the GaAs TO, a satellite peak band marked by an oval centered at 250 can1 can be observed, which can be attributed to the GaAs relative QD interface (IF) phonon signal (named GaAs IF for short).

Therefore, it is obvious that the LT growth process of GaAsBi SRL has prevented the In/Ga intermixing and left a relative abrupt interface between InAs QD and surrounding matrix, which is consistent with the explanation for the abnormal PL intensity development in Fig. 3a.

However, prolong the paste age will reduce the surface chemical activity to a large extent, produce more voids between two adjacent filaments and form relative weak interfaces between layers, therefore producing negative influences to the mechanical integrity of the printed structures (Panda et al. 2017).