Sentence examples for reinforcement factor from inspiring English sources

Reinforcement factor (Rf) has also confirmed this strong mechanical interlocking of diamond with the matrix which was ~ 1.7 and ~ 3.0 times higher than CNT and graphene, respectively.

In this work, an estimation of the reinforcement factor ξ of the Halpin Tsai equations used to calculate the transverse stiffness E2 is provided.

Rheological properties of the samples are represented in terms of the strain-dependent reinforcement factor, which highlights the contribution of the filler.

Based on acquired dynamic stress strain relations, dynamic strength increase factor, fiber reinforcement factor, critical strain, and energy absorption are studied versus both strain-rate and fiber volume fraction.

Combining the structural information with a quantitative analysis of the reinforcement factor, the aggregate size and compacity (10 40%) as a function of volume fraction and pH can be deduced.

In partial correlations, the relation between the ASI and the RFS negative reinforcement factor remained significant when controlling for RFS positive reinforcement smoking motives, but the correlation of ASI with RFS positive reinforcement motives was not significant after controlling for RFS negative reinforcement motives.

The reinforcement factors, i.e. the normalized modulus and yield strength, were found to be constant over a wide temperature range (25 180 °C).

As clearly seen in Fig. 7, the rheological-reinforcement factor of EPDM-GO/rGO compounds shows inferior rheological-reinforcement factor behavior, compared to those of NBR-GO/rGO compounds reported earlier (Mensah et al. 2014; Mensah et al. 2015), especially at higher filler loadings.

It was found that reinforcement form factor was influenced by the factors arc length, torch travel speed, melting rate and resistance heating of the electrode.

Results of reinforcement showed that factor of safety increased more than 1.15.

The remediation included the removal of the wall face and reconstruction increasing the connection capacity between the segmental concrete units and the reinforcement by a factor of three.