Sentence examples for reference strengths from inspiring English sources
The strength assessment should be referred to and characterised in terms of two well-defined reference strengths: the results of linear bifurcation and plastic collapse analyses.
A reference strength data shall be considered within the specified range of fluid-to-binder ratio.
Wide range of reference strength data would be useful to proportion the materials for the given strength at ambient conditions.
The overall compressive strength gain was up to 39% for CW2 and CW3, whereas CW1 achieved roughly the reference strength, with a small 4% increase.
Instead of repeated laboratory trials, desired results can be achieved through simple calculations by introducing the experimentally determined reference strength value in the phenomenological model.
The shear yield strengths of the shear plate and side braces are found to provide consistent lower-bound reference strength for plate trunnions.
The shear yield strengths of the shear plate and side braces are found to provide a consistent lower-bound reference strength for the tested specimens.
Post-capping strength degradation It is defined by translating the post-capping branch toward the origin; however, the branch slope will keep constant and it will move inward to reduce the reference strength.
A reference strength range is suggested for applying the 1 mm stress method to the fatigue strength evaluation of fillet welded joints in bending on the base of analysing available test data.
The sensitivities of the mechanical response are evaluated regarding the uncertainties in design variables such as Young's modulus of fibers and matrix, fiber reference strength, shear yield stress, fiber volume fraction and shear parameter defining the shear stress in the inelastic region.
Since the procedure of EN 1288-2 is proved to be ineffective because the induced stress state is not uniform and equibiaxial, a supplementary experimental campaign is reputed necessary, considering that the reference strength of glass in product standards has been determined with this testing method.
