Sentence examples for reduction in location from inspiring English sources

Results from the initial trial demonstrated a considerable improvement over the conventional TOA source location method, with a reduction in location error from 4.81% using the conventional TOA technique, to 1.77% using "Delta T" location.

Specifically, prevention should include risk reduction in plant location and design and safety legislation [ 17].

As shown in Figure 2B, linkage analysis on AF with the GGA5 markers using groups 1 and 4 showed a slight increase in LRT (12.6) at 174 cM, which contributed to a small reduction in the location confidence interval for GGA5 AF QTL from 156 cM-187 cM (31 cM) to 158 cM-184 cM (26 cM).

We estimated Canadian and U.S. health benefits from NOx and VOC emission reductions in each location or grid cell (i.e., each 36 × 36 km box).

We apply our methodology to estimate the response of national short-term mortality (valuated as an overall "health benefit") in Canada and the United States from short-term exposure to O3 (and NO2 in Canada) to emission reductions in each location across North America.

Previous simulation studies 20 43 44 show that rigorous social distancing interventions involving school closure coupled to contact reductions in other locations may be highly effective in reducing the attack rate within a developed country setting.

Surprisingly, the results showed that the reduction in scores resulting from location changes was resistant to all kinds of measures designed to aid refocusing of attention.

For space dimension reduction, the location data in the range of 30 m around the pipeline showed the range of activity.

Vodafone said a reduction in headcount and office locations in places where the two firms overlap was likely but specific numbers are yet to be determined.

These improvements might be related to the shot blasting as well as to the reduction in average speeds at locations where speed radars were installed.

The process reveals that optimization of the original geometry of blower, at 1.5 times width of impeller, 24° tongue angle and 10% reduction in volute outer radial locations, pressure head and flow uniformity increases compared to other cases; this improvement takes place due to reduction in the non-uniformity of flow at impeller outlet and losses inside the volute passages.