Sentence examples for reduced deflection from inspiring English sources

Correction factors were derived for different wind directions and reduced deflection in the full-scale data-set by <3°.

Additional advantages of the present technique are the enhanced moment carrying capacity, reduced deflection and crack width and improved ductility.

The ultimate strengths of the repaired beams were equivalent or significantly higher than those of the control specimens, although reduced deflection capacities were registered after repair.

A novel mechanical structure design with reduced deflection offset is reported.

Similar to the advantages of conventional prestressed concrete compared to RC, prestressed, externally bonded reinforcement has several advantages over externally bonded reinforcement including reduced crack widths, reduced deflections, reduced stress in the internal steel, and increased fatigue resistance (Michels et al. 2013; Correia et al. 2015).

As in posttensioning, this gives the precast floor members a slight upward arch, which reduces deflection and permits the use of shallower members.

This reduces deflection, or sagging, and cracking of the concrete when the service load is applied and permits the use of somewhat shallower floor members.

Cast-iron columns carried iron trusses of three different spans 7.3 metres (24 feet), 14.6 metres (48 feet), and 21.9 metres (72 feet)—in riveted wrought iron; spanning between the trusses were ingenious "Paxton gutters" made of wooden compression members above iron tension rods that prestressed the wood to reduce deflection.

It was observed that, using high volume fraction of SMA wires can significantly reduce deflection.

Using a structural analysis, parameters representing the stiffness of the frames in reducing deflection ratios and horizontal strains were derived.

It was observed that, the presence of embedded SMA wires in the beam can effectively reduce deflection.