Sentence examples for reduce the electronic from inspiring English sources

However, these terminations obviously reduce the electronic conductivity and the rate performance in the charge/discharge process.

It has been demonstrated that the incorporation of electrically insulating particles will reduce the electronic conduction by an 'electron-trapping' mechanism (ideally) without affecting the ionic conductivity.

Thermally sensitive binder (TSB) [13, 14] was developed to reduce the electronic conductivity once the battery was overheated, and thermal runaway retardant (TRR) [15] was employed to lower the ionic conductivity.

The surface COC bonds reduce the electronic band gap energy compared to that of the fully H-terminated phase, while the nanowires with SiOSi bonds have a larger band gap.

The proposed WDM network uses a Multi-channel Control Architecture (MCA) for two reasons: First to reduce the electronic processing bottleneck and second to optimize the performance measures by dynamically dividing the control channels into two groups according to the knowledge of the stations status (free or backlogged).

The enhancement on ionic conductivity or sintering behavior ceria-based electrolyte can either be done by adding a carbonate phase to facilitate the utilization of the ionic-conducting interfaces, or by addition of alumina as insulator to reduce the electronic conduction of ceria.

The camera has a resolution of 8 megapixel with 16 bits dynamic range; its CCD sensor is cooled for reducing the electronic noise during the acquisition.

The strain-induced localization effect reduces the electronic hopping integral t, which leads to a larger value U/t and avails to a stronger antiferromagnetism.

The increasing amount of rGO within the h-BN moiety plays fascinating role by reducing the electronic work function while increasing the density of state of the electrode.

The two layers of membrane separator inside the cell were replaced with a mono-layer separator, which significantly reduced the electronic inner-resistance due to the improvement of mass transfer.

Since the modular approach reduces the electronic noise levels processed by the preamplifier it is possible to use long shaping times up to 50 μs which optimizes the spectral resolution.