Sentence examples for recirculation test from inspiring English sources

The methods are based on the collection of an additional piece of information in the form of a second injection (or recirculation) test at a same location, or in the form of an additional head or flow observation along the well/probe.

Recirculation was tested with nominal contact times of 30, 60 and 120 min and the goal of 95% removal could be achieved already at the shortest contact times at a PAC dose of 10 15 mg/L.

Several recirculation scenarios were tested using a custom-programmed HVAC (heat, ventilation, air conditioning) unit that varied the recirculation door angle in the test vehicle.

It let publishers start showing more ads, introduced Page Like and email sign-up buttons and is now testing recirculation units so news outlets can drive readers from one article to another.

To examine the recirculation theory, we tested the deep veins by occluding and refluxing saphenous veins 10 cm below the sampling site.

The importance of extra-splenic killing and recirculation could be tested with non-destructive sampling of the blood immediately after transfer (that is, over the short timescale during which cells are migrating into the spleen) to test that the ratio of pulsed to unpulsed targets in blood is preserved.

For all the tests, recirculation air was switched on when the in-cabin particle number concentration was about 50,000 particles/cm, an average and typical concentration observed in this study when recirculation was off, and the subsequent variation of the particle number concentration was recorded by the CPC.

The results show that the lean limit flames are located inside a recirculation zone at all tested pressures.

The experiments conducted in a 4-m-long and 8-cm-diameter test section with recirculation facilities.

The bioactive HFMs were then potted in a model gas exchange device (0.0084 m2) and tested in a recirculation loop with a CO2 inlet of 50 mmHg under steady blood flow.

For test series with fly-ash recirculation during coal combustion, the continuous attrition model under steady-state sulphation-attrition conditions yielded values that resembled the experimental results.