It is expected that the proposed N2 C2 C3 cycle could have a reasonably high efficiency and the potential of great liquefaction capacity.
The volumes of water in the two sections are optimized to achieve a maximum water temperature at a reasonably high efficiency.
Over the last decade, a type of photovoltaic device called the dye-sensitized solar cell (DSSC) had emerged as a technology that can achieve reasonably high efficiency and low manufacturing cost.
This shows the possibility of replacing the liquid electrolyte in DSSCs by electro-spun polymer nanofiber based gel electrolyte and thereby minimizing some major drawbacks associated with liquid electrolyte based solar cells while maintaining a reasonably high efficiency.
One of the key conclusions from this analysis is that while the optimal efficiency for regenerative CLC cycle was the highest of the three (56% at 3 bars, 1200 °C), the combined-regenerative cycle offers a trade-off that combines a reasonably high efficiency (about 54% at 12 bars, 1200 °C) with much lower gas volumetric flow rate and consequently, smaller reactor size.
We further confirmed the utility of CR7T in driving gRNA expression by using it in the generation of mutations at two target locations in white, both with reasonably high efficiencies (Table 1 and Figure S3).
These designs can fit the second-order response surface model with reasonably high efficiencies but with only a much smaller run size.
In any case, a high efficiency of the coagulant is easily reached with reasonably low CDF dosages and the response of the system is very similar to that observed by previous researchers (Ayranci and Duman 2007).
DSSCs fabricated with SCNTs-PVP CE presented reasonably high conversion efficiency of 4.5% with high open circuit voltage (VOC) of 0.718 V, short circuit current (JSC) of 12.14 mA/cm2 and fill factor (FF) of 51.7%, while the bare SCNTs CE showed the conversion efficiency 2.34% with VOC 0.680 V, JSC 13.7 mandm2 and FF 26%.
Its mesh-objective nature, together with the high efficiency of the energy crack propagation criterion, makes using coarse meshes to obtain reasonably accurate simulations possible.
