The electromagnetic parasitic noises arising in the microelectronics chip is one of the main reason of failure occurrences.
However, the reason of failure after multi-hit could be clearly explained with the help of used numerical simulations.
Diagnostic system will allow detecting possibility of abnormal situations in advance, defining possible reason of failure and suggesting ways of failure correction.
The reason of failure usually, found in the form of cracks, are sorted out by special instrumentsand are mended by hand, which is unsatisfactory because cracks often needs cautious work to detect& repair them.
The reason of failure to get superhard Cr Cu N coatings is a combination of incomplete monolayer coverage due to ultra-low Cu content, (220) preferred orientation, and the grain size of CrN with less than 20 nm.
Conductive Cu layers were developed on ABS surfaces only from the H2SO4, H3PO4, and CH3COOH baths but were not from the HNO3 one, and the possible reason of failure of the HNO3 bath is discussed.
Several authors identify improper femoral tunnel placement as a common reason of failure.
This explains the reason of failure of PLO because PLO adjusts the packet size based on the packet retransmission history.
The reason of failure is high sensitivity to small differences in the image which happen under variable illumination conditions.
EMBED_FAILURE (pred_state_id, succ_id, error_desc): In case of a failure, an InP replies back with a description outlining the reason of failure using error_desc.
