Sentence examples for rear layer from inspiring English sources

It was observed that saturation current density (J s) reduced significantly after the addition of the SiNx:H layer on the rear layer.

This suggested that using shear resistant materials for the front layer and tensile resistant materials for the rear layer may improve the ballistic performance of fabric panels.

The analysis showed that the retention of carbon-rich species (hydrocarbons and soot) in the double-layered configuration occurs mainly in the first catalyst layer (front layer), therefore resulting in a cleaner second layer (rear layer).

Applying a wider strip of adhesive enabled the adhesive to flow around the width of the array and bond to the rear layer, thus fully securing the array in silicone.

It was found that the front layers of fabric are more likely to be broken in shear, and the rear layers of fabric tend to fail in tension.

However, the results of the eight types of fabric rear layers involving STF impregnated fabric of this study suggest that STF impregnated fabric can be a promising candidate for the improved rear wall of a space shield.

The results clearly demonstrated that the first layers (during impact) were subjected to high shear stresses and that the yarns in the rear layers underwent severe in-plane tension stresses.

The experimental results showed that placing woven fabrics close to the impact face and UD material as the rear layers led to better ballistic performance than the panel constructed in the reverse sequence.

This sound-absorbing blind works because sound is absorbed extremely well if there's a rear air layer, 50-200 mm thick, between the blind slats and a wall, when the blind is attached in the usual way.

The contact pattern of copper wire was attached by the low-temperature (160 °C) lamination method simultaneously to the front and rear TCO layers as well as to the interconnecting ribbons arranged outside the structure.

In order to eliminate the influence of the thickness of CdTe and recombination at its rear surface, the layer is considered to be sufficiently thick in this case.