Injection molding tests were then carried out with this system by using a general purpose isotactic polypropylene and a cavity 200 mm thick in order to check the effect of surface heating on reachable flow length and morphology of the molded parts.
Overall, the boundary of what is reachable slightly overestimated arm length (0.88cm) but was not modified by the brain stimulated site (F 2,12) = 0.82, p = 0.45) nor by the SOA (F 4,24) = 0.062, p = 0.99, see Figure 9a).
Then, the boundary of what is reachable was determined according to arm length and the transient inhibition of the motor system, which affected reaction times, did not modify the decision criteria.
The diameter was defined as the longest path length between any two reachable nodes in the network.
All markings, which can be reached from a given marking by any firing sequence of arbitrary length, constitute the set of reachable markings.
This observation is however consistent with the finding in previous studies of a consistent bias towards overestimating true arm length when judging what is reachable [15] [19].
In this study we investigated whether changed judgments of objects' distances after tool use can be ascribed to a scaling of the reachable range or to changed judgments of arm length.
The network diameter is the maximal length of the shortest path between two reachable nodes in the network.
When using this method, the general agreement was that what is reachable with the hand depends mainly on the distance of the target relative to the length of the arm [15] [19].
In the test phases, the participants were simply to estimate the length by positioning the planar surface so that it coincided with the perceived distance reachable with the handheld rod.
In contrast, under lower mutation rates without length restrictions, an increase in the success rate can be related to an higher diversity of reachable genomes coding for individual based solutions.
