Sentence examples for reach maximum efficiency. from inspiring English sources

In order to reach maximum efficiency, both fuel and oxidizer must be pumped into the engine's combustion chamber at high rates, under high pressure, and in suitable mixtures.

In the designed three load adjusting modes, the system can reach maximum efficiency over 59% with four types of biomass gases.

Smaller countries face a steeper cost of providing public goods, and their small internal markets do not allow to reach maximum efficiency in the production of private goods (except if they enjoy the proximity to a large integrated market such as the European single market).

On all cancer cell lines tested, including primarily TRAIL-resistant A549 cells, already low concentrations of TRAIL (1 10 ng/ml) in the presence of SNS-032 (300 nM) were sufficient to reach maximum efficiency in killing these cells.

When you help the helpers, your dollar can reach maximum efficiency.

Much fuel was necessary to heat the earth, clay, or brick interior of an oven, and, once the right temperature was reached, maximum efficiency could be achieved only if many loaves were baked.

As a general rule, removal of all the investigated metals was stimulated with increasing metal levels in the three investigated procedures reaching maximum efficiency at the highest applied concentration while COD removal decreased.

We also suggest that the current CGB8 gene with the c8-155C/c8-147del/c8-144C/c8-142A preached haplotype has already reached maximum efficiency.

In other words, if a given muscle reaches maximum efficiency, then its activity is limited at simultaneous growth in activity of other muscles.

It is important to conduct the gas injection at miscible condition so as to reach maximum recovery efficiency.

In this work a theoretical optimization of the thermo-photovoltaic system was attempted in order to reach maximum conversion efficiency by an optimal choice of the emitter's operating temperature and the pass band wavelengths of the optical filter that is used to reflect the inefficient frequency converted photons back to the absorber-emitter unit to be recycled.