Sentence examples for ratios of yield from inspiring English sources

The ratios of yield stresses (0.86) and ultimate tensile strengths (0.83) at 295 and 77 K were quite close to the ratio of Young's moduli (0.85), suggesting that the strengthening mechanism is predominantly controlled by long-range athermal obstacles.

Bottom figures: ratio of yield stress multiplied by θ.

Ratio of yield stress to wall shear stress, τ y/τ w.

The ratio of yield strength to peak strength is between 0.7 and 1.0, with a slightly decrease after 340 °C.

Relationship between shoot elongation rate (SER) under stagnant flooding condition, relative grain yield (ratio of yield under SF to that in the control) and survival rate (SR).

A rust tolerance index (RTI) was computed for each test line as the ratio of yield from unprotected plots to yield from protected plots.

At the macroscopic, continuum scale, Bingham number is the ratio of yield stress to viscous stress, and describes the bulk motion of the fluid.

However, the observed permanent deformation, Davg, was found to relate to the ratio of yield acceleration, ay, and the peak horizontal ground acceleration, amax.

Compared with hot-rolled martensite dual phase steel, ferrite-bainite dual phase steel has high ratio of yield strength to tensile strength (YS/TS) and low elongation.

As the concrete grade increases from C40 to C80, the specimens show higher brittleness with a ratio of yield to peak loads changing from 0.6 to 0.9.

The ratio of yield strength to elastic modulus was assumed to be in the range 0.0005 0.02 and the hardening coefficient was assumed to be between 0 and 0.4.