Sentence examples for ratios of fusion from inspiring English sources

At least one of the ratios of fusion spanning reads vs. corresponding wild-type exon-exon spanning reads was greater than 2. Number of fusion spanning reads ≥ 100 or outlier z-score value ≥ 5.

The ratio of fusion energy produced in the pellet explosion to the driver energy is called the pellet gain.

In 1997, JET generated 16 megawatts of peak power with a fusion gain (the ratio of fusion power produced to the net input power) of 0.6.

(D F) Quantification of mitochondrial fusion rate (D), mitochondrial fission rate (E), and the ratio of fusion rate over fission rate (F).

This is reflected by the small energy magnification factor Q (ratio of fusion power to injected power) required by the propulsion system when compared to that of the power reactor.

According to this model, the hardness ratio of fusion zone to pull-out failure location and the volume fraction of voids in fusion zone are the key metallurgical factors governing type of failure mode of AHSS spot welds during the tensile shear test.

The phage display system practice will need the optimization of fusion coat proteins to wild-type ones since a high ratio of fusion protein may lead to the inefficient assembly of phage particles and depending on the application a low ratio may not elicit the desired results (Gupta et al. 2003).

The obtained results indicate that design calculations for the tritium breeding ratio (TBR) of fusion power reactors employing a HCPB type breeder blanket are conservative.

However, to obtain tailored weapon effects or to meet certain weight or space constraints, different ratios of fission yield to fusion yield may be employed, ranging from nearly pure fission weapons to a weapon where a very high proportion of the yield is from fusion.

Six operating factors were retained and the results considered were the production yield, the particle volume-surface average diameter D32, the residual humidity, the ratio of the fusion enthalpies of the polymorphs α and β′/β and the normalized peeling force.

When the J-chain was transiently co-transfected, a ratio of IgM fusion protein DNA to J-chain DNA of 10 1 was chosen.