The burned gas Markstein length increases with the increase in the equivalence ratio, the tendency being the same as that of hydrogen/air flames and methane/air flames.
The overall mechanical properties of natural fibre reinforced polymer composites are highly dependent on the morphology, aspect ratio, hydrophilic tendency and dimensional stability of the fibres used.
Response rates tended to be lower in the STN-lesioned group than in the sham-lesioned group in the lower ratios, this tendency becoming less apparent as the ratio increased.
More than two thousand high-resolution hydrofacies models representing seven groups of alluvial settings are built to test the effects of varying facies proportions, mean length and its anisotropy ratio, juxtapositional tendencies, and sub-facies heterogeneity.
Both the side-chain reduction and the S/G ratio increase tendencies were also observed in the eucalypt wood pretreated with laccase alone, although the changes produced were much more moderate than those obtained in the presence of methyl syringate.
Pick: Packers Colts (9-5) at Chiefs (2-12) Sunday, 1 p.m. Line: Colts by 7 Winning seems to cure all problems, so Colts fans will not focus on Andrew Luck's terrible completion percentage, his so-so touchdown-to-interception ratio or his tendency to make a lot of mistakes early in games.
H/C ratio showed a tendency to decline with the increase of F/A ratio.
Buckling modes corresponding to increasing slenderness ratio show a tendency towards three-dimensional buckling deformation (global buckling) at a slenderness ratio greater than a certain length.
We theoretically propose a dynamic mode and time slot assignment scheme for TMDM-PON based on inter-ONU priority rating, in which the time delay and packet loss ratio's variation tendency are investigated by simulation.
It is a condition affecting relatively young individuals with an almost equal sex ratio and high tendency to recur: it is estimated that almost 50%% of stone patients will present recurrence within 10 years [2].
At higher power densities (>1600 kW/cm2) the I D to I D′ ratio have a tendency to increase toward the corresponding values found for vacancy-related and sp3-type defects (Fig. 4a) [13].
