Sentence examples for ratio of pull from inspiring English sources

The amount of bound protein is expressed as the ratio of pull down to input (PD/input).

"I have almost every person I work with perform a 2 1 ratio of pull-to-pushing exercises," Gambino says.

For a better description of the switching behavior, a switching efficiency S is introduced in eq 2, which is defined by the ratio of the pull-off forces at a preload above and below the buckling preload Pb: 2 A value of S = 0 indicates no switching behavior, and S = 1 resembles a perfect switch where adhesion can be completely turned on and off.

MBP-Mia1p-MutNES4 could interact with Alp14p, albeit with a diminished efficiency as compared to the wild type Mia1p (Fig. 4C, 0.26∶1 ratio of Alp14p-myc pulled down by MBP-Mia1p-MutNES4 and MBP-Mia1p respectively).

The critical parameter for determining between JKR and Hertz is the ratio of load to pull-off force 5 For indenting the flat and curved specimens at a load of 1000 μN these ratios are 4.1 and 20.2, respectively.

The 1 1 1 molar ratio of components in pull-down assays that allowed successful isolation of the ternary complex may have contained insufficient PEX14N to trigger unloading due to the higher PEX14N affinity of the N-terminal W-X3-F/Y motif of PEX5 [12].

If Japan's debt-to-gross domestic product ratio of 200 percent can't pull its economy out of the quagmire, why should America be any different?

Since the dispersion ratio is governed by the ratio of the fluid drag force to the pull-off force, the current work suggests that DPI performance is the result of the balance of those two forces.

It is also shown that the cumulative Weibull distribution function can be used to describe the DPI performance, which is governed by the ratio of the fluid drag force to the pull-off force.

According to this model, the hardness ratio of fusion zone to pull-out failure location and the volume fraction of voids in fusion zone are the key metallurgical factors governing type of failure mode of AHSS spot welds during the tensile shear test.

Tox promoter (nt −2105 to −1867) enrichment was calculated as the ratio of the NFIL3-specific antibody pull-down to the IgG control pull-down.