Sentence examples for ratio of acceptable from inspiring English sources

In big cities, where the ratio of acceptable organs to needy patients is worst, the wait is five to eight years and is expected to double by 2010.

The ratio of acceptable travel time by shuttle bus over the travel time by URT is shown in Fig. 2b.

The gain, measured by the ratio of acceptable models between constrained and unconstrained dockings, is, on average, 2.2 (sigmand.2), and analysissis of variance for data with repeated measures (with and without constraints) indicates p values ranging from 0.003 to 0.00004, depending on the total number of models kept, so the results are all statistically significant.

Even after transmission over 20 km SMF and splitting ratio of 32, acceptable transmission performance and widely separated constellation diagrams for the 16-QAM signals are achieved, with bit error rate (BER) of 10−6 for DS signals and 10−3 for the US signals which can be reduced down to 10−6 by using forward error correction (FEC).

The results show that full graded RCC with a water-binder ratio of 0.45 0.50 is acceptable for water consumption of 70 kg/m3, a sand ratio of 30% and a stone combination of 20 30 30 20.

Total RNA concentrations were obtained using a NanoVue spectrophotometer (GE Healthcare, Buckinghamshire, UK) with an A260/A280 nm ratio of ≥1.8 deemed acceptable for downstream analysis.

According to Morais and Queda (2003) and Jordening and Winter (2008), a C N ratio below 20 is indicative of acceptable maturity, while a ratio of 15 or lower is being preferable for agronomic use of composts.

First, our analyses push the limit of acceptable ratios of information (sample size) to structural parameters in our statistical model.

The road regions are filtered based on dominant boundaries, acceptable ratio of road width/length, combing with color filter results.

A false positive ratio of c.75%% is not acceptable even for modest standards of strict NER, which does not seek to disambiguate persons from each other.

In order to guarantee a minimum rate of profitability of each manufacturer, a minimum acceptable ratio of production rate to production capacity (utilization factor) is considered for each of them.