Sentence examples for rates of applied from inspiring English sources

The overall effect of inoculation on NN and NDW in this soil type was higher than for the corresponding N rates of applied without inoculation (Fig. 1a, b), thus showing the competitive advantage of inoculated Rhizobium over the indigenous rhizobial population.

Hence, the objective of this study was to investigate the effect of naturalized common bean rhizobia population on the N rates of applied when alone or in combination with Rhizobium inoculation on nodulation, yield and yield traits of common bean in major growing areas of eastern Ethiopia.

In relative terms, the K losses were higher than N and P. As regards total nutrients applied through pig slurry, losses through surface runoff were of 2.74, 1.61 and 1.37% of mineral N; 6.29, 5.01 and 3.51% of available P and 17.16, 9.01 and 11.14% of available K, for the three rates of applied pig slurry, respectively.

From the identified strategy trials, data were extracted concerning definitions of targets and success rates of applied strategies.

However, TBA attended deliveries did report lower rates of applying something other than antiseptic to the cord stump.

Thus there is little evidence from similar trials with which we can compare the increases in rates of applying nothing to the cord and use of clean cord ties found in this study.

Although the stress maintains its rising trend by increasing density to values higher than the operational density, the rate of applied stress decreases.

In general, wheat grain yield consistently increased as the rate of applied filter cake increased to the highest level but showed the tendency of stopping increment after 60 tons/ha for bagasse ash application.

In the present study, we demonstrate that stretch-induced JNK, p38 and ERK phosphorylation and stress fiber reorganization depend on the rate of applied matrix strain.

The effects of the duration of time and the rate of applying stress (i.e., loading) as a function of time are examined.

Rate of applying wood in the construction industry in Malaysia has gone down from about 60%to7%7% over the last 40 years.