In this paper, forming limit diagrams at three strain rates and forming limit diagrams at temperatures ranging from 650 oC to 850 oC were established.
Here, we show that different fibroblast-like and epithelial cell lines maintain normal proliferation rates and form functional cell-matrix contacts in DLW-fabricated 3D scaffolds of different mechanics and geometry.
We grouped genes with comparable average substitution rates and formed three bins of equal size: slow, medium-speed, and fast-evolving genes.
Different enzymes metabolize different drugs, metabolize the same drugs at different rates, and form different metabolites, all of which influence toxicity and dosing.
They are sensitive to skin indentation, respond to sustained mechanical stimuli with slow and intermediate adaptation rates, and form longitudinal lanceolate endings around hair follicles (Abraira and Ginty, 2013, Delfini et al., 2013, Li et al., 2011, Lou et al., 2013, Lumpkin et al., 2010, Seal et al., 2009).
Pinus radiata has undergone three generations of breeding for growth rate and form to date.
In humid air, DLC coatings had a coefficient of friction (c.o.f). of 0.1, a very low wear rate, and formed a graphitic transfer film in friction contact.
If the dissolution rates of two reactants (i.e. TiO2 and Na4TiP2O9) are similar, both reactants would dissolve in the molten salt with the same rate and form the nanostructures once it reaches supersaturated condition.
On the contrary, lactomil (consisting of lactose and maltodextrin) was considered as the most suitable excipient for yeast starter because it yielded a rapid drying time of 2.5 h and the highest yeast cell survival rate and formed a fine powder.
LDL particles from asm+/+/ldlr −/− mice fed on the high-fat diet exhibited different electrophoretic mobility, with some migrating very slowly (aggregated LDL) and others migrating at a higher rate and forming a secondary band (oxidized LDL).
