For longitudinal specimens the influence of the loading rate on the FT and DBT was studied in the loading rate range between 0.06 and 18 MPa m1/2/s.
Static micromixers (made by microlithographic Si/glass chip technology) and PTFE tubes were applied for the flow-through experiments in the flow rate range between 5μl/min and 4 ml/min.
A temperature range used here is between 77 and 296 K, a strain rate range between 10−9 and 10−2 s−1 and true strain below 0.2, where structure evolution depends on strain but scarcely on temperature and strain rate.
Specimens of A1 steel are fractured in a brittle mode by a slipping-off mechanism in a strain rate range between 2.7×10−4/s and 2.7×10−2/s, where opening of a crack occurs along an active slip plane.
Combinations of parameter values in deme 2 were order in relation to the width of migration rate range, between the critical upper and lower values, which promoted stable polymorphism.
The output L20OCV was a group of predictors that are based on the gene expression of sets of 1 to 10 genes with error rate range between 0.37 (for single gene) to 0.079 (for 10 genes), see Figure 2A.
