Sentence examples for rate pore diameter from inspiring English sources
Contact angle, droplet diameter, interfacial tension, membrane thickness, shear rate, pore diameter and trans-membrane pressure are system variables.
Faster stirring rate would produce samples of smaller pore diameter, but when rotation speed reaches 4000 rpm and higher the changes in pore size is minimal.
Another interesting result is that for the same NAAM geometry (i.e. thickness, interpore distance and pore diameter), the etching rate is much faster in those NAAMs fabricated in malonic acid.
Additionally, the fluoride content in the electrolyte will increase the length and growth rate, but has little influence on the pore diameter.
The variance in liquid liquid demixing velocity at the inner surface of the PVC fibers is influenced by the lumen liquid rate, which can lead to the alteration of pore diameter and pore diameter distribution.
Results indicate that decreasing the heating rate increased the specific surface area, pore volume and pore diameter.
These three facts suggest that anodization temperature has a strong effect on the pore growth rate during anodization, but a small influence on the pore diameter or morphology.
The capacity for osteoinduction was found to be dependent on the rate of the porosity and microstructure, with a mean pore diameter of 8 nm, depending on the amount of the solvent water, which enables the homogeneous osteoconversion.
NAA-based DBR can be achieved by taking advantage of the fact that a wet etching applied after the anodization to enlarge the pore diameter (pore-widening step) has a different rate depending on the used anodization voltage [23].
Since flow rate through different pores varies by the fourth power of the pore diameter, the fractional amount of liquid that passed through each pore was calculated and used to derive a filtration survival probability function for a cell with a given MCD (Fig. 5B).
The application of hot water droplets significantly improved the exchange rate between the solvent and non-solvent phases, which increased the average pore diameter.
