Sentence examples for rate of the existing from inspiring English sources

Offering FWPs is not only related to the job seeker's perception of organizational attractiveness, but also increases the organizational attachment and retention rate of the existing employees.

Numerical simulations are performed to demonstrate that the presented protocol can improve the convergence rate of the existing fixed-time consensus protocols without increasing control input.

The LRS is increased (slightly) with retention time, however, long time retention of 48 h at a CC of 300 μA is obtained (Figure 11b), which may be the higher dissolution rate of the existing filament at lower CC.

The proposed method achieved a detection error rate of less than 5.71 % for all cases, while the error rate of the existing PCA/LDA method dramatically increased to 13.3 % for four and five fingerings.

Smoothed finite element method (SFEM) was recently proposed by the authors to improve the accuracy and convergence rate of the existing standard four-node isoparametric finite element method (FEM) by 2×2 quadrature in the static analysis.

Using our PSHAs produced a substantially higher localization index than using general medical hospital services areas (0.69 vs. 0.23), meaning that our model correctly predicted geographic utilization at three times the rate of the existing model.

The error rates of the existing method such as the methods in [10, 15, 21] are also shown for comparison.

The degree of environmental adaptation is hardly quantified, so a qualitative rating of the existing alignment is set forth.

This allows for control of cell density (and therefore unit efficiency), including by controlling the rate of introduction of new algae, based on the growth rates of the existing population.

We estimated the annual loss rate that best reflected the dynamics of existing practising doctors, then applied this rate to the existing physicians, plus the newly licensed physicians flowing into the pool over the next two decades (from 2012 to 2030).

In addition, the high sampling rate requirement of the existing techniques makes the localization process computationally intensive and imposes the need for sophisticated hardware.