Sentence examples for rate of receivers from inspiring English sources

In our system, we equalize transmission rate of transmitters in layer n and equalize receiving rate of receivers in layer (n+1) for all n∈{1,2,…,N}.

If we assume the transmission rate of transmitters in layer n or the receiving rate of receivers in layer (n+1) are either unequal, the optimization will be extremely difficult.

As seen in Fig. 2, the sum rate loss is small when the transmit power is lower than 40 dBm, this is because that the sum residual interference is too small to degrade the rate of receivers.

Whether or not the decreased response rate of receivers directly stems from the deceptive use of the calls cannot be determined until these latter possibilities are rigorously tested.

Using this property, it can be derived that the rate of receiver diversity is no greater than that of code diversity.

By discussing the two categories (t=0.5 can be treated as a special case in either category), we can obtain the achievable rate of receiver diversity strategy: R DF recd = sup min R ( t, P s d 1 + P 2 ), ( 1 − 2 t, P 2 ), tR ( P sr ) if t < 0. 5 ; sup min R ( 2 t − 1, P s d 1 ), ( 1 − t, P s d 1 + P 2 ), tR ( P sr ) if t ≥ 0. 5. (14).

For the former, as the sampling rate of the receivers is increased, some of the errors decrease to near zero.

This introduces a new degree of flexibility in channel adaptation, which leads to a decrease in the packet error rate of both receivers.

Baraniuk [2] used CS ideas for SAR imaging and proposed two potential improvements: (i) eliminated the matched filter (MF) in the radar receiver and (ii) reduced the required sampling rate of the receiver A/D converter.

A similar, but more complicated, set of equations provides the three mutually orthogonal velocity components and the drift rate of the receiver's clock.

The input sampling rate of each receiver is 500 Hz.