Sentence examples for rate characterization from inspiring English sources

Hopkinson bars are used to probe rates of 102 104 s−1, an important region in strain rate characterization associated with dramatic increases in the dynamic strength.

The tribometer performances are demonstrated through a study of coefficient of friction, shudder sensitivity, and wear rate characterization for a dry clutch friction material.

This paper will address hopper and spline design, feed rate characterization and modeling, particle residence time, and the effect of moisture and hopper vibration on the effective delivery of ZnO powder to the thermochemical reactor.

To obtain proper input values for the calculation, neutron flux and gamma dose rate characterization were carried out using adequate portions of cow or pig liver covered with demineralized water simulating the preservation solution.

With the above service rate characterization, we can express the effective rate (in bits per channel use) at a given SNR, error probability ε, blocklength m, and QoS exponent θ as R E = - 1 m θ log e E | h | 2 ε + ( 1 - ε ) e - θ m r ̄ bits/channel use, (13).

The "in flight" dynamic characterization showed that the proposed system can be up to five times faster than the state of the art for commercial gyros at higher yaw rates; the regime yaw rate characterization demonstrated a high and constant pirouette speed.

Next generation microscopes may exploit multi-color sources, increased detector parallelism, increased frame rate, or stroboscopic structured illumination to extract higher-dimensional, higher resolution, higher frame-rate characterization of a specimen.

The proposed approach would scan this entire bandwidth at much faster rate enabling characterization of a large number of crystals than is currently possible through mechanical scanning with a confocal microscopy based spectroscopic technique as well as providing functional dopant profiling which is not currently possible with conventional approaches.

The assay tended towards a higher rate of characterization in samples with viral detection values of <48 copies/ml (62.5%) when compared to samples with no detectable HIV-1 RNA (41.7%).

The combined use of computations, experiments and high-strain-rate material characterization has, in many cases, supplemented the data achievable by experiments alone at considerable savings in both cost and engineering man-hours.

The existence of relationships between the concentrations of the pharmaceutical compounds, their removal rates, the characterization parameters of influent wastewaters and the WWTP control design parameters has been studied by means of statistical analysis (correlation and principal component analysis).