Sentence examples for rate by weight from inspiring English sources

The results of the precipitated mass rate (by weight) as well as the soluble solids concentration (°Brix) were evaluated by means of three variables – precipitation temperature, centrifugation velocity and centrifugation time interval.

They work as tea-leaf pluckers and are paid at a piece rate (by weight of leaves plucked).

At the algorithmic level, the solution is to re-balance the error rate by weighting each type of error with the corresponding cost.

At the algorithmic level, a first solution is to re-balance the error rate by weighting each type of error with the corresponding cost [ 44] In the case of decision tree learning, other algorithmic solutions consist of modifying the splitting criterion [ 45], adjusting probabilistic estimates at the tree leaf or adjusting decision thresholds [ 46].

Cathodic polarisation curves were evaluated to yield the corrosion current density icorr and the corresponding corrosion rate Pi, which was compared with the corrosion rate evaluated from hydrogen evolution measurements, PH, and the corrosion rate evaluated by weight loss measurements, PW.

Its corrosion rate calculated by weight loss and hydrogen evolution, immersed in Hank's solution at 37 ± 0.2 °C for 240 h, were both less than 0.5 mm/year.

Corrosion rate measurement by weight loss of coupon specimens especially for the uniform corrosion is the simplest and the best service condition technique.

Table 2 The results of weight loss corrosion test obtained in juice samples taken from various units during 2009 2010 campaign period Juice Metals Briks pH Corrosion rate determined by weight loss test (mpy) Raw juice AISI 304L 16.52 6.75 0.0042 Raw juice AISI 316L 16.52 6.75 0.0037 Thin juice AISI 304L 15.82 8.75 0.0025 Thin juice AISI 316L 15.82 8.75 0.0025 2A Evap.

For example, because female workers are paid on a piece-rate basis (by weight of tea leaves plucked), women who pluck large amounts of leaves and have higher earnings are likely to be in good physical condition.

The wear rate is measured by weight reduction and chain elongation.

Degradation rate as observed by weight loss and reduction of molecular weight and mechanical properties depended on the composition of the blends.