Sentence examples for ramp down to from inspiring English sources

A basic schematic of the protocol used for performing GBS is shown in Figure 2. Oligonucleotides comprising the top and bottom strands of each barcode adapter and a common adapter were diluted (separately) in TE (50 µM each) and annealed in a thermocycler (95°C, 2 min; ramp down to 25°C by 0.1°C/s; 25°C, 30 min; 4°C hold).

Heat 2 min at 60°C and ramp down to 25°C, at a rate of 3°C per min. Unless otherwise specified, the ligations were performed with 2 µM of each oligonucleotide, in 10 µl of ligation buffer, supplemented with 1 unit/µl of Rnasin Plus, 0.5 µl of ligase (20 U/µl for Rnl1, 10 U/µl for Rnl2 and 5 U/µl for Dnl), 0%–50% PEG and incubated 3 h at 20°C.

From the river, the neighborhood descends, like a long ramp, down to an open-water, brackish marsh called Bayou Bienvenue.

Is the operation reserve large enough when the load increases and, at the same time, wind generations ramp down to zero in half an hour?

The questions to answer the renewable intermittency impact are as follows: (1) Is the operation reserve large enough when the load increases and, at the same time, wind generations ramp down to zero in half an hour?

The paper finds that reaching that goal would require that greenhouse emissions "ramp down to zero immediately" and that scientists deploy means, starting in 2050, to actively remove greenhouse gases from the atmosphere.

Such estimates are consistent with a data brief issued last February by the University of California at Berkeley Labor Center, which identified industries with the highest percentage of employees working slightly over 30 hours and thus vulnerable to being ramped down to just under that threshold.

In a typical growth, 100-nm GaSb buffer was firstly deposited at 580°C, then the temperature was ramped down to 520°C for the growth of InAs/GaSb SL.

Subsequently, the temperature is ramped down to 485 °C, and the growth of the 300-nm-thick buffer layer is initiated at a growth rate of 1000 nm/h and a V III beam equivalent pressure (BEP) ratio of 7. The substrate temperature is ramped down by the end of the buffer layer and stabilized in order to ensure a stable substrate temperature of 450 °C during the W-QW growth.

Santanu, an executive at a smaller outsourcer wrote this explanation: "One of our clients needs to rebalance their team size every two months ramping up to 30 people for around two months and then ramping down to 10 people for the next two months.

Initially, the voltage is kept at 40 V for 3 h and then it is ramped down to different voltages (e.g. 30 V, 34 V, 36 V, 38 V and 39 V) at a ramping rate of either −1.0 V s−1 or −0.5 V s−1 in one time and two-time aged electrolytes.