Sentence examples for raising reaction from inspiring English sources

Therefore, by raising reaction time, the Ag-NWs continue to grow until the ions in the solution gets depleted.

PCP conversion was increased by raising reaction temperature, increasing oxygen partial pressure, reducing the initial concentration of PCP and prolonging reaction time.

The selectivity for 4,4′-diisopropylbiphenyl (4,4′-DIPB) in the isopropylation of BP over dealuminated HM such as HM 128) decreased with raising reaction temperatures or with decreasing propylene pressures.

Raising the reaction temperature or prolonging the reaction time would accelerate the transamidation rate and degree.

It has been reported that the PLQY of CQDs was related to the N-doping amount in CQDs [17, 27], and thus, many works have attempted to increase the N-doping amount in CQDs by prolonging the reaction time even up to 19 h or raising the reaction temperature to 260 °C [11, 23].

On the other hand, the yield of the dehydrogenated products (cyclohexene) increased slightly with the gradual increase in the reaction temperature (for samples OMS-2RA and OMS-2RC) and low yield of dehydrogenated products obtained on raising the reaction temperature to 400 °C.

The simulation results show that hydrogen addition has significant effect on raising methane reaction rate and flame stability.

By continuously raising the reaction time to 5-40 h, newly reduced Ag atoms would grow on the top of the well-defined 1st-layer AgNPs to form second layer AgNPs (2nd-layer) as shown in Figure 1c,e,f,e,f

The seeded emulsion polymerization, basically designed similar to the previous reports except raising the reaction temperature at the end, was conducted for preparing irregular shaped polymer particles incorporating hydrophilic polymer inside the particles as well as on the surface.

A cement product was fabricated via a simple hydration process using a derivative of a C12A7 cement precursor reacting with de-ionized water while raising the reaction temperature to 100 °C.

It was found that endpoints were not affected by: (1) changing from P4VPHCl to P2VPHCl; (2) using P2VPHCl samples of different molecular weights; (3) the addition of salt to the titrant or (4) by raising the reaction temperature from 298 K to 323 K. Elemental analysis of precipitates revealed, however, that PEC were deficient in polyanionic units.