Sentence examples for radial feed from inspiring English sources

Two module types, based on a linear or radial feed of the test atmosphere to the test system, were used for these studies.

If A d is the nominal cutting depth, then the uncompensated machining error changes the actual cutting depth of the nominal cutting tool position point into A d -δ and sets the deformation of the cutting tool in the radial feed direction which is ey and the nominal cutting width which is R d, so then the actual cutting width becomes R d -ey.

It was determined that the performance of the designed cycle directly depends on the technological system stiffness; number of cycle steps depends on the stiffness of the technological system; when calculating the surface roughness limitation of the radial feed, an area was formed in the interval in the workpiece rotation frequency.

In this way, the to-be-shaved gear and the shaving cutter will be in line contact, and only a radial feed motion of the shaver is needed to generate the required pressure for the shaver to cut the excess of material on the gear tooth surfaces.

In addition, the deviation of cutting-edge curve, residual material and the land lack caused by the modified radial feeding velocity, are taken into consideration.

The work contains suggestions on how to improve the performance for the RK-core processing shafts cutters with radial constructive feed and describes the processing method allowing one to exclude the reciprocating harmonic motion.

To implement this method, a design procedure was developed for a disc cutter with radial constructive feed which allows performing the calculation of the milling and processing modes design parameters.

The ring stiffness condition in radial axial ring rolling is related to the factors of ring size, rolling ratio, position angel of guide roll, rolls sizes, position of cones, radial and axial feed speed and friction condition.

The equations for axial, radial and rotary feeding velocity of the workpiece in the flute NC grinding process are also derived.

The input parameters were the radial depth of cut, feed rate, and contact angle.

Neural networks can be of different types, like feed forward, radial basis function, time lag delay etc.