Many tests and research efforts on scheme feasibility, process standardization, component qualification and blanket assembly were reviewed.
In this paper, the design, assembly, qualification tests of the PSD and some of the performance measured on the ground are presented in detail.
After completion, they will be used for the development and qualification of the assembly procedures and for full-scale hydraulic tests.
In the present paper, design consideration, fabrication techniques and post-assembly qualification tests to guarantee reliable structure of the capillary evaporator for loop heat pipe (LHP) with high heat flux transport capability has been presented.
The dynamic qualification of the windtunnel assembly under wind-off condition was carried out in the department's test laboratory.
Qualification of electric penetration assemblies for CAP series nuclear power plant is introduced, including identification of qualification requirements, selection of representative specimens, development of qualification test plan, and implementation of qualification tests.
This paper presents a physics of failure-based approach to virtual qualification of advanced area array assemblies against solder fatigue failure.
A description of the module design, the assembly procedures and the qualification tests is given.
In this work, we describe the SiPM carrier boards, the assembly process and the qualification tests performed, before and after assembly, on the focal plane modules to qualify the procedures.
Therefore design and licensing of an experimental facility for the fuel qualification test, including the small scale fuel assembly with four fuel rods, the required coolant loop with supercritical water and safety and auxiliary systems, is the scope of the project "Supercritical Water Reactor Fuel Qualification Test" (SCWR-FQT).
